Perhaps you are one of the Hyundai Elantra N Wipers Hit the Hood who had the frustrating situation of Elantra N Wipers Hit the Hood.
Well, this damages the wiper blades and contributes to the total malfunction of the wiper, causing discomforts and costly fixes if not detected early.
The beauty about it is that once you understand why this happens, you can deal with it so it will not happen again.
In the following comprehensive guide, we are going to analyze the most common causes of the Elantra N wipers hitting the hood and offer step-by-step troubleshooting and repair tips.
Problem Understanding: Elantra N Wipers Hit the Hood
The wipers of Elantra N hit the hood since they are striking the car body by wiper blades. Perhaps this is a result of some improper installation or position of wiper arms or blades.
These wipers tend to cross the limit of their sweep and then start hitting the hood and producing ugly marks on it.
Perhaps this may further raise some extra problems. It would avoid extreme damage to the wipers as well as to the car itself.
Indicators That Your Wiper is Hitting the Hood
Discover when your Elantra N Wipers Hit the Hood from the signs listed below;
- Visible Damage: In case you establish scratches or scuff marks appear on the hood at the lower part of the windshield, most probably contact happens during its function.
- Unusual Noises: In case the wipers are activated, one would hear some squeaking or clanking against the bonnet which is being done.
- Uneven Wiper Alignment: If the blades wipe more to one side than they are supposed to or if they align themselves at an angle where they should not be when idle then these could be signs of wrong installation of wipers or some new issue in the wiper mechanism.
Symmetrical Wiper Arms: The Primary Problem
Most of the cases where the wipers of Elantra N Wipers Hit the Hood is a case of misaligned wiper arms.
A wiper is designed to pass over a specified length so that the sweeping action of the wiper is effective on the windscreen without touching the body.
It normally hits the hood if this arm aligns even after being worn out or wrongly fitted wiper arms and even after accidents.
How to Diagnose Misalignment
- Turn off the wipers and observe their return to the parking position
- Examine whether arms are sagging too much down from the lower windshield
- If your wiper is misaligned, then this is a case of your old wiper arm getting outdated, which makes them get out of calibration
Wiper Motor Failure and jerky motion of blades
If the wiper motor is bad, this will cause jerking or even movement off course by the blades. In other instances, a bad wiper motor will also introduce a pattern to the inconsistent motion of the blades.
The outcome may be bumpering the Elantra N Wipers Hit the Hood in operation. Listen for grinding and clicking noises that indicate some fault with the wiper motor.
How to Test the Wiper Motor
- Engage your wiper and watch clearly if some noises may be unusual to the ear .
- Poor engine in past days; there is the case of grinding and missing in your ways.
- Choose the engine in which all can use, and you will maintain to run efficiently at an efficient good quality 6. Loose Wiper Linkage, broken End
This is the linkage system that connects the wiper motor to the wiper arms such that the latter moves in synchronization.
The loose linkage or linkage getting some breakage in connection will deny the arms proper functionality. Thus, the blades travel too high and hit the hood. It could be due to worn-out bushings or just faulty work.
Inspection on Wiper Linkage
- Watch out for the following worn signs of rust, cracks, and looseness around the wiper linkage.
- Broken parts require the whole linkage to be replaced so that it can have movement as intended
Faulty Mounting of Wiper Arms
Another major cause of the Elantra N Wipers Hit the Hood is bad installment of the wiper arms.
When you are removing the wiper arms for maintenance or replacement then putting them wrongly in place, it will cause an incorrect angle which makes the wipers sweep too high and hit the hood. I
f you have had your wiper system serviced, check the installment properly.Installation of the Wiper Arms:
- Take out the wiper arms from the wiper motor.
- Mount the arms in place. Make sure it is mounted with an angle. This way when not in use, it would be sitting at the bottom portion of the windshield.
- Check the wipers not to hit the hood.
How to Align Malaligned Wiper Arms
- It’s really easy to align malaligned wiper arms. Here’s how to do it.
- Loosen the nut holding the wiper arms at the wiper motor, to remove the wiper arms
- Change the angle and position of the wiper arms so they hang correctly from the base of the windshield
- Tighten the nut that holds the wiper arms into place.
- Check the wipers so that it does not touch the hood of the vehicle, and easily run smoothly
Replacing Wiper Blades to Prevent Damage
If worn-out wiper blades are the cause, then the problem will be solved by changing them. New wiper blades will restore proper movement and ensure that the wipers will work without hitting the hood. When replacing wiper blades, always opt for the right size and type for your Elantra N Wipers Hit the Hood.
- How to Replace Wiper Blades
- Lift the wiper arm away from the windshield.
- Insert into the vehicle and press the tab at the upper end of the blade holder so that the old blade is loosened and comes out
- Mount a new blade onto the wiper arm which automatically snaps in
- Turn on the wiper; it should be washing the glass windshield accordingly
Wiper Motor Malfunctions
This problem is solved if a wiper motor needs to be replaced, that is a fact for the problem. This will easily allow the wiper blades to properly operate without having the blades slap onto the hood.
In addition, it would easily be identified by a certified mechanic to acquire the proper fix to make adjustments on the auto as well.
Preventive Maintenance Avoids the problems in future
Regular maintenance will avoid the wiper of your Elantra N Wipers Hit the Hood. Sometime, one will be checking up on one’s wiper system to end up discovering some issues that may include a misalignment of the blades, worn-out blades, or even motor problems even before they end up occurring in real life.
Follow these guidelines in keeping your wipers healthy:
- Change your wiper blades frequently if they end up wearing out.
- While on maintenance or even on repair, the wiper arms should be set up correctly.
- Oil the wiper linkage so that chances of rusting and friction become less
Time to See the Pro
Once all these basics have failed and still, the solution to its removal is now non-existent, it’s time to have it seen by a pro.
This technician goes to the source and does all his specialized repairs that require equipment and lets your Elantra N Wipers Hit the Hood do its intended operation with minimal further puking from it on your hood.
Conclusion
It is a nightmare problem to be hit into the hood of a wiper on Elantra N Wipers Hit the Hood but curable.
Or rather, it perhaps is but has been slightly misaligned, or perhaps only the bad blades or defective motor, maybe even damage within the linkage itself.
It saves one some damages no matter the cause, by knowing the problem before the damages turn costly on the hood of a car.
A few of these solutions include maintaining a car through constant check up, regular adjustments, and even proper fitting of spares.
If this doesn’t cease the problem, wait no more; visit an expert car mechanic so that your wipers get to the best condition.
